Site Map / Register

Forum

Please Log In to post a new message or reply to an existing one. If you are not registered, please register.

NOTE: Some forums may be read-only if you are not currently subscribed to our technical support services.

Forums » Prof-UIS Tech Support » Add TRACE() in MainFrm::OnCreate(), but get nothing in debug window

Subject	Author	Date
Add TRACE() in MainFrm::OnCreate(), but get nothing in debug window	Jia Hong Li	Mar 13, 2007 - 9:40 PM
Why ? I am tracing some parameters. Add TRACE( PARAMETER ), and get nothing. So, I try to use TRACE("..........."), but get nothing again in the Debug Window. PS: I try this test in any sample will get the same result.
Re:Add TRACE() in MainFrm::OnCreate(), but get nothing in debug window	Suhai Gyorgy	Mar 14, 2007 - 6:07 AM
I’m not sure if that helps, but try using TRACE0("..........\n") for messages with zero parameter, TRACE1, TRACE2, etc for messages with 1, 2, etc parameters. Those variations usually work for me.
Re:Re:Add TRACE() in MainFrm::OnCreate(), but get nothing in debug window	Jia Hong Li	Mar 14, 2007 - 8:52 AM
It’s work now. I have another question about thumbnail, and I send mail to support@prof-uis.com. Could you check that problem for me ?? thanks
Re:Re:Re:Add TRACE() in MainFrm::OnCreate(), but get nothing in debug window	Technical Support	Mar 15, 2007 - 6:45 AM
Actually we have not yet received your email. You can also send it to profuis at gmail.com.